Avermedia capture card software6/22/2023 ![]() ![]() (It should not be because it was just disabled.) The green circle with the check mark above it indicates that you have it set as the default device.ĭouble-click on Stereo Mix. If you do not see the option, it is already the default. ![]() Right-click on Stereo Mix and click Set as default device. If it says Disable then do not click on it as it is already enabled! Right-click on Stereo Mix in the list and click Enable. Right-click in the area below and check Show Disabled Devices if it does not already have a check. If you do not see enable, then the device is already enabled and you can move on.Ĭlick the Recording tab at the top of this window. Right-click on AVERMEDIA_HD-1 and click Enable. If you do not see a device named AVERMEDIA_HD-1 right-click in the list and select Show Disabled Devices. You can ignore the default communications device as it does not apply to this situation. ![]() The green circle with a white check mark over it is the indicator of which device is my default device. NOTE: I renamed my headset accordingly to make identification easier. In my case it is Realtek High Definition Audio that has been labeled Speakers. Right-click on the audio device that is your onboard sound card and select Set as Default Device – if this option does not display, then it is already the default device. Right click on the speaker icon in your system tray (bottom right hand corner of the window's desktop near the clock). (Not to the audio in on the capture card!) Run the audio cable from the line out on the sound card on the gaming computer to the line in on the sound card on the streaming computer. Run the HDMI cord from the gaming computer to the HDMI in on the capture card in the streaming computer. You will need both the HDMI cord and the 3.5mm to 3.5mm audio cable that came with the capture card. Different versions of windows will have slightly different procedures. This guide was written with Windows 7 64-bit as the operating system. This guide also assumes that all of the above hardware and software is installed properly, has all of the necessary drivers and supporting software installed and is generally at a default configuration. This guide also assumes that the AverMedia RECentral software is already installed. This guide assumes you already have Open Broadcaster Software installed. It also assumes that both the streaming computer and the gaming computer have working sound cards with 3.5mm audio out and audio in ports (besides the capture card and the USB headset) and that you are using purely HDMI between the gaming computer and streaming computer. It also assumes that you have a USB headset with a microphone installed on the gaming computer that the footage is being captured from. This guide assumes that you have the AverMedia Live Gamer HD capture card installed into the streaming computer – one that is used to capture the footage on another computer and handle the stream so the other computer does not take a performance hit at all. The computer that has the capture card in it and is running the stream will be referred to as the streaming computer. I bring you… How To Use a USB Headset with AverMedia Live Gamer HD on another pcįor the duration of this article I will refer to the computer that is playing the game that is being recorded as the gaming computer. ![]() (Please respond in comments if you have had luck with other software using this method so I can update the article!) It works for Open Broadcaster Software and more than likely works with any other similar capture software. The main problem is capturing both the game audio and the audio from the microphone on the USB Headset. Many gamers have experienced a road block when using an AverMedia Live Gamer HD capture card in a dedicated streaming computer to capture game footage on another computer while using a USB Headset. ![]()
0 Comments
Leave a Reply. |